|
The following are some key factors influencing the
design of the Egg Module Coop.
Design Considerations
Space
requirements
The Lift Kids coup design necessitates 1.5 square feet per bird. Therefore, a 600-bird coop should have a minimum of 900 square
feet (or 300 square meters). Our building design calls for a building 20 feet
wide and 45 feet long, plus an additional 5 to 10 feet in length for a storage
room. However, the length can be tailored for different flock sizes. For
example, a coop for a 500-bird flock would need to be 20 x 37.5 feet.
Scope
The poultry operation will consist of an initial
coop capable of housing either 50-to-100 or 500-to-600 birds. The two tiers
allow villages to experiment with different levels of risk. The smaller coop
may be more appropriate in isolated villages where there is limited access to
markets and supplies, especially feed. The
issues of disease management, temperature control, and predator theft (human
and animal) are key in this design decision.
Nests
Birds need
privacy when laying the eggs. The glistening and shiny appearance of the wet
egg can trigger cannibalism against the egg and against the hen laying the
eggs. 4 birds can share a nest; each nest is about 2 ft x 2
ft. A typical flock of 600 birds would need 150 nests. Nests can be
double-stacked and run along both the sides and center of the coop.
Light control
Young birds need dark conditions, while mature birds lay more eggs
with increased light. The birds sense light through their skulls, not just
their eyes. The maturation process is enhanced by managing the light. Due to
these factors, the ability to control light is desirable and should be
incorporated in the design and construction of the barns.
Temperature control
Natural ventilation
and cooling is critical in considering temperature control through coop design.
In cold climates or higher elevations, temperature control will require heating
systems. (Heating systems are also required for the arrival of day-old chicks.)
Insulation
To hold
down the roof temperature and prevent heat radiation during sunny days, it is
necessary to insulate the roof to an R-value of 5. Material like 1-inch-thick
foam-type insulation with hard fiberglass (or similarly durable material) glued
to the lower side should prevent birds and other critters from pecking or
chewing away material from the underside of the roof. A thatched roof could
provide an effective R-value.
Ventilation
An
effective method for ventilation would be a continuous 6-inch-wide ridge
opening running the length of the building. To prevent rain from entering the
coop, the ridge opening should be capped with a small roof-type structure that
is 12 or 14 inches wide, located 12 inches above the ridgeline. This will allow
warm air to exit the opening without being restricted by this ridge cap.
Feed control
Feed should be distributed simultaneously to the entire flock. Otherwise,
birds lower in the pecking order will be crowded out and will not get enough feed,
while large birds will over-consume.
Water
A continuous supply of water is vital for layers. Nipple drinkers
are ideal for preventing disease; a ratio of 1 nipple per 15 hens is preferred.
Capturing rainwater reduces labor and may be essential if the coop
is located far from a well. Rain barrels will collect and hold water from the
roof during storms. This storage tank will be connected to an interior nipple
drinker system. Excess water could also be channeled into a drip
irrigation system for a garden around the coop.
Floor
Concrete is the preferred flooring material for Lift Kids coop
designs. A separate roost area helps manage the waste products. It is
preferable to avoid hard woodchip floors.
Isolation
Coops should be in a relatively isolated part
of the village, as isolation is imperative for mitigating the
risk of disease outbreak. Therefore,
it is advised to keep the coops in the back of the village, away from roads,
paths, and other highly trafficked areas. Human traffic should be limited to as few people as possible; ideally
only 2 or 3 people would ever have access to the coops. In
addition to limiting human traffic, it is vital to limit the exposure to wild
animals. Sturdy building, as well as tree-trimming above the coop, will reduce
the chances a wild animal will enter or contaminate the coop. Finally,
ventilation is an important consideration; building the coop in an open area
will facilitate natural ventilation.
|